Unwind a reel of fish tape and guide it under the carpet.
Mat to run wire under.
Tape the wire to one end and thread it through.
Unwind the wire until it reaches the other side of the room or the location where you want the cable to emerge from the carpet.
To use simply unwind the reel and the nylon or steel wire inside should get pushed out.
I ve used in the past a length of welding rid.
I have a 2 inch hole in each corner of a room apart 12 feet apart.
About 2mm thick so it s stiff.
Perhaps make a plastic pole with a base which you place under one of the car wheels to run across to.
This is an acceptable way to connect multiple mats to the same thermostat.
I want to run a cable between them but so far.
Any suggestions on how to run a cable under floorboards without lifting them.
Some electricians will use a junction box to connect multiple cold tails to a power lead and then connect that to the thermostat.
We provide our customers with helpful videos so they can complete their diy installation.
95 floor cable protector d line fc83h medium duty linkable floor cable cover protect cables prevent a trip hazards 1 8 meter l cable cavity 30mm w x 10mm h black yellow 4 6 out of 5.
Sticky mats can be used under all the same floor coverings as loose wire but are different in that the cables are already pre spaced and attached to a mesh mat meaning all you need to do is roll out the mat rather than individually lay wires.
When installing multiple heaters you must check that the total load a of the system does not exceed the maximum load of the thermostat.
Op why not run your 13 amp cable over the pavement above head height from a upstairs window.
If it s a straight run then use a long piece of wire.